Rena MACH 5 Guide de dépannage télécharger pdf (Page 56)

SECTION 3

OPERATING THE PRINTER

well the nozzles are performing, in each color channel of the Printhead. New: This function can now be

accessed by pressing the “Print Ink Channels” button; located on the top, non-operator side, of the Print

Engine.

Print Color Bars Page – Prints a series of 7 color bars to show how well the Printhead is mixing colors

and printing.

Ink Usage Menu

This tool is provided for the purpose of estimating the

amount of ink usage for a particular print job.

This information can be used to estimate

how many

pieces can be printed before each Ink Tank is empty

(assuming all Tanks are full).

The numbers provided are in nano-liters (nL).

Each Ink Tank holds a maximum of 250 ml

(250,000,000 nL).

For example: If we use the info from the top row of this

chart; each piece/image used an average of 2387 nL

(19097/8=2387) of Cyan ink. Therefore the Cyan Ink

Tank should be empty after approximately 104,733

pieces (250,000,000/2387= 104,733).

Ink Estimation Mode – Checking this box lets you predetermine how much ink a given job may use prior

to printing. This can be useful for determining per piece costs. The job is sent to the Printer and loads, but

does not print. Once the job is loaded, the Ink Usage chart shows the estimated

amount of ink (by color)

that the job will use.

NOTE: The estimating process will take as long as the job would take to print (i.e., if the job would take 1

hour to print, the estimate will take 1 hour to display.) If a job is incomplete (paused, interrupted), an

apteryx symbol (*) will be shown next to the page count (Pages) number.

When this feature is selected the Toolbox will display: “Ink Estimation Mode”

NOTICE! The printer will not feed or print if the “Ink Estimation Mode” is selected.

Please be sure to un-check the “Ink Estimation Mode” when you are ready to print the job.

Network Configuration Menu

Permits you to view, enter or change settings to connect the Printer

to your network via the Ethernet port.

Please refer to the section titled “Connecting the Printer via

Network (Ethernet Port)” for detailed instructions.

Note: To set these printer parameters; you must initially install the

printer Driver via USB and connect to the printer via USB.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 127 128

Pas de commentaire

Rena MACH 5 Guide de dépannage Page 56