Rena MACH 5 Guide de dépannage télécharger pdf (Page 26)

SECTION 2

INSTALLING THE PRINTER

Procedure (Installing the Ink Tanks):

This procedure assumes that you are installing Ink Tanks into a printer that doesn’t have any Ink Tanks

installed. If you are replacing an empty Ink Tank, please refer to the “Replacing the Ink Tanks” section.

Install the Ink Tanks as follows:

1. Power the Printer ON. Plug in the printer. Turn the printer’s Main Power Switch ON; then press

the control panel’s ON/OFF button. Wait about 45 seconds for the print engine to power-up

(ON/OFF button will illuminate).

2. Open the M Series Toolbox. Go to All Programs, select the “Memjet” folder, select the “M

Series Driver” folder and Open the “Toolbox”.

Tip: If you receive warning that Windows Firewall has blocked some features of this program.

Please select Private Networks and then click on Allow Access.

A web browser will open and display

the “User Interface” screen. On the left

side of the screen you will see

information about the System Status

and Ink levels. With no Ink Tanks

installed all Ink status levels for

“CKYMK”, will be displayed with a

question mark (?) below each color

position and the colors are not filled-in.

3. Click the button labeld “Replace Ink Tanks”, located in the Toolbox User Interface screen.

This disconnects Printer communication with the Ink Tanks and allows safe installation and

replacement.

Once the “Confirm” screen, shown to the right,

displays, it is safe to install/remove Ink Tanks.

IMPORTANT: DO NOT

press “Continue”

until after

you have installed the Ink Tank(s)

and closed the Ink Tank Latches.

4. Open the Ink Tank Door (hinged at

bottom).

5. Open the Ink Tank Securing Latches

[A].

6. Remove the new Ink Tank(s) from

packaging.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 127 128

Pas de commentaire

Rena MACH 5 Guide de dépannage Page 26