Rena MACH 5 Guide de dépannage télécharger pdf (Page 35)

SECTION 2

INSTALLING THE PRINTER

3. [A] & [B] Start with the Head Media

Guide positioned as shown in “A”, on

previous page.

Note: The “Tab”, on the end of the

Guide, fits over the front side of the

metal “Support” plate.

While lightly pressing up on the Guide;

slide it to the left, until the cutouts in the

Guide aligned with the ears on the back

side of the metal “Support” plate. This

will allow the Guide slide up closer to

the printhead surface; as shown in “B”.

[C] Push the Guide to the right, to lock

it in place.

NOTE: While the Clamshell is still

open, verify that the Head Media Guide

is aligned with the Printhead Cartridge

as shown in “C”.

4. Once the Head Media Guide has been

installed; Wipe the Printhead Nozzles

end to end using distilled water and a

damp lint-free cloth.

5. Carefully close and latch the Clamshell.

Then close the Top Cover.

6. Remove in reverse order.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 127 128

Pas de commentaire

Rena MACH 5 Guide de dépannage Page 35