Rena MACH 5 Guide de dépannage télécharger pdf (Page 102)

SECTION 6

TROUBLESHOOTING

Examples of Print Quality Issues (including possible causes and solutions)

The Memjet printhead cartridge contains 70,400 inkjet nozzles. These nozzles are divided into ten rows;

two rows of nozzles for each color channel. Due to the high number of nozzles; it is not uncommon for

some nozzles to become contaminated, dehydrated or clogged.

The following examples were produced using a Five Band Color Purge YKCKM. A similar purge pattern

can be performed using the “Print Ink Channels” button; located in the Toolbox, Diagnostics Menu.

Air in Printhead Nozzle Area:

Air in the printhead nozzles will show as jagged, irregular shaped lines of missing color. Lines are normally

wider than one nozzle.

Possible Solutions:

• Press the “Full Clean Printhead” button, located in the Toolbox, User Interface screen, and lightly

tap on the ink tubes and Printhead Cartridge as the system is circulating ink. This can help

dislodge air bubbles within the Printhead and Ink Tubes.

Note: It is not a problem if air bubbles accumulate in the ink hoses at the non-operator side of the

printhead; since this is the outgoing side.

• Deprime and Reprime the system. Release the Printhead, using the “Release Printhead” button.

Remove and re-install the Printhead Cartridge. Then close printhead latch to re-prime the system.

Lightly tap on the ink tubes and Printhead Cartridge as the system is priming; to help dislodge air

bubbles.

• Contact Service person to have them inspect the system for possible air leaks (damage to ink tubes

or ink revolver couplings).

• Instead of powering the printer off, when not in use, leave the print engine powered-up; so it can

perform automatic maintenance routines.

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 127 128

Pas de commentaire

Rena MACH 5 Guide de dépannage Page 102