Rena MACH 5 Guide de dépannage télécharger pdf (Page 112)

SECTION 6

TROUBLESHOOTING

106

Service Station Problems

WARNING! Many of the issues related to Service Station function will require a qualified Service Person,

or properly trained person, to diagnose and fix these issues. If you haven’t been properly trained on or don’t

feel comfortable performing these procedures; please contact your Service Support Representative.

CONDITION PROBLEM SOLUTION

Service Station Drive

Motor stalls.

Service Station was not installed

properly.

Wiper roller securing latches are

not closed; preventing Service

Station sled from moving

properly.

Damaged Service Station

Jammed gear train due to broken

post or improperly seated gears.

Damaged Motor

Eject Service Station. Cycle print

engine off/on. If drive motor turns

without stalling then motor is OK.

If you have trouble ejecting the

Service Station, call Service

Support.

Before re-installing Service

Station, make sure: wiper roller

latches are closed and not

damaged.

Replace Service Station.

Call Service Support.

Wiper Motor doesn’t turn

or stalls

Cable not connected.

Squeegee blade wedged, not

seated properly.

Debris build-up on blade and

rollers, increasing friction.

Bad wiper roller motor

Verify ribbon cable and motor

cable are properly connected to

board on side of Service Station.

Reseat squeegee blade.

Clean rollers and blade.

Replace Wiper Motor Assembly or

Service Station.

Color mixing occurs after

wiper roller performs a

cleaning

Wiper Roller is over-saturated.

Squeegee blade is not seated

properly, damaged or bowed.

Allow printer to sit, powered ON,

for 2-3 hours or replace wiper

roller.

Reseat wiper roller squeegee

blade. If squeegee blade is

damaged/bowed, replace

component or Service Station.

Service Station cannot be

removed from the Print

Engine

Wiper Roller Latches were not

completely closed when the

Station was installed. Latches

now hooked on bottom of paper

path.

Service Station was manually

installed too far with Lifting Arms

up.

Damaged Lifting Arms

Carefully unhook Latches from

bottom of paper path and secure

latches.

If wiper roller latches are

damaged; replace Wiper Motor

Assembly or Service Station.

Call Service Support.

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 127 128

Commentaires sur ces manuels

Pas de commentaire

Rena MACH 5 Guide de dépannage Page 112

Commentaires sur ces manuels

Produits connexes et manuels pour Imprimer et scanner Rena MACH 5