Rena MACH 5 Guide de dépannage télécharger pdf (Page 43)

SECTION 3

OPERATING THE PRINTER

7. Adjust the position of the Rear Media Support

Guide, so that it is centered under the width of

your media. This guide slides side to side.

Tip: The Rear Media Support will slide, without

loosening the knob.

8. Adjust the position of the Media Support Wedge to

accommodate the length of your media.

Place a second piece of media onto the single piece

that is already in the hopper. Make sure the second

piece of media is against the separators.

Loosen the locking screw and reposition the wedge

so the trailing edge, of the second piece of media, is

hitting the bend in the wedge; as shown

9. Place a stack of media into the hopper.

Make sure that the stack is fanned so the bottom

piece is closer to the separators then the top pieces.

Tip: When loading an empty hopper. Place one

piece of media so it is directly against the tips of the

separators. Then place the fanned stack of media on

top of this single piece.

NOTE: The amount of media that can be stacked

on the printer is determined by the weight of the

material. The feed section may not feed larger and

heavier media when the stack is full. If this is the

case, reduce the amount of media in the stack until

the media feeds properly.

10. Paper Feed Test. To check for proper media

separation and feeding. Turn the printer’s Main

Power Switch ON; then press the control panel’s

ON/OFF button. Wait about 45 seconds for the

print engine to power-up (ON/OFF button should

illuminate). Press and hold the Paper button for 5

seconds. The printer will feed one piece of media

through the printer.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 127 128

Pas de commentaire

Rena MACH 5 Guide de dépannage Page 43