Rena MACH 5 Guide de dépannage télécharger pdf (Page 27)

SECTION 2

INSTALLING THE PRINTER

7. Insert the new Ink Tanks (label side up)

into their appropriate color slots

[B].

CAUTION! Be sure each Tank is installed

into the proper color slot. If you force the

Ink Tank into the wrong slot, you will

contaminate the ink system and professional

service will be required.

INSTALLATION TIP: To help insure that

the Ink Tanks are seat properly. Insert the

Ink Tank into the appropriate Ink Station,

then pull the Ink Tank back about an inch and push forward firmly. This will help insure that the

“septum needles” penetrate the seals on the Ink Tanks.

8. Close and lock all three Ink Tank

Securing Latches.

IMPORTANT: Make sure both sides of

the Latch are engaged at the bottom.

9. Click on the button labeled “Continue”, in the

Confirm screen of the Toolbox.

10. Watch the Toolbox screen on your computer. You should see all the ink

colors fill-in; if all the Ink Tanks are properly installed and recognized.

If an Ink Tank color does NOT fill-in, and a question (?) mark or “out”

condition is displayed below the ink color; this indicates that the printer

does not recognize the Ink Tank (Unable to communicate with QA Chip) or

the ink level sensor doesn’t see any ink in the Tank.

Verify that the Ink Tank Securing Latches are fully closed and locked.

Then click on the button labeled “Refresh Ink Levels”.

If the ink color still does not fill in; the QA Chip contacts or Ink Level

Prism may need to be cleaned. Please refer to the “Operator Maintenance”

section for information on “Cleaning Ink Tank Contacts & Prism”.

Tip: Even new Ink Tanks can have dirty QA Chip contacts. This is not always visible to the eye.

11. Close the Ink Tank Door.

NOTE: If a Printhead Cartridge is not installed the Systems Status line in the Toolbox will display the

“MISSING PRINTHEAD message. To install the Printhead Cartridge; please proceed to the section

titled “Installing the Printhead Cartridge”.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 127 128

Pas de commentaire

Rena MACH 5 Guide de dépannage Page 27