Rena Envelope Imager XT 3.0 Guide de dépannage télécharger pdf (Page 18)

SECTION 2

INSTALLING THE PRINTER

Print Unit Positioning (Vertical Address Positioning)

The print units are the device that contains the pen stalls and inkjet cartridges. To adjust the vertical position of the

address (printed image) on the media, you must move the Print Units to the desired print positions.

1. Loosen the Print Unit Securing Knobs. See Figure 22.

2. Slide the Print Units to the desired positions as shown in Figure 22.

3. Tighten the Print Unit Securing Knobs.

4. Envelope Imager XT 3.0 Only. Reposition the Paper Transport Guide [A] so that it helps hold down the

media before it enters under cartridges 1, 2 or 6, as shown in Figure 23.

Note: The printer’s default orientation is “up-side-down” as viewed from the operator side. This is considered

“normal” orientation. Horizontal print position is adjusted via your software (mailing program).

Figure 22

Envelope Imager XT 4.0

Figure 23

Envelope Imager XT 3.0

Envelope Imager XT3.0/XT4.0 Operations Rev. 6/15/2007

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 55 56

Pas de commentaire

Rena Envelope Imager XT 3.0 Guide de dépannage Page 18