Rena EasyFeed Lite Manuel d'utilisateur

EASY FEED LITE FRICTION FEEDER OPERATOR MANUAL Rev 02-04-13

MAINTENANCE 7 Maintenance This section describes maintenance that an experienced operator can perform. If any service or maintenance is required be

8 Specifications Easy Feed Lite MATERIAL HANDLING: Minimum Size: 3.5" (88.9 mm) L x 5" (127 mm) W Maximum Size: 12" (304.8 mm) L

9 Neopost USA 2013. All rights reserved

SAFETY PRECAUTIONS THIS EQUIPMENT PRESENTS NO PROBLEM WHEN USED PROPERLY. OBSERVE THE FOLLOWING SAFETY RULES WHEN OPERATING THE RENA EASY FEED LI

TABLE OF CONTENTS i TABLE OF CONTENTS Getting Acquainted Feeder and Connections 1 1 Assembly and Installation Choose a Location Assembly Installi

GETTING ACQUAINTED 1 Getting Acquainted Controls and Connections 1 Tabber/Feeder Interface Connector – Interface Cable plugs i

ASSEMBLY AND INSTALLATION 2 Assembly and Installation The Easy Feed Lite Feeder is designed to feed material from single sheets up to 1/4" in

ASSEMBLY AND INSTALLATION 3 2. Attach the Rear Media Guide Support using the Knob provided [A]. NOTE: The two outside holes fit over the socket h

ASSEMBLY AND INSTALLATION 4 Installing the Feeder (with T-650 Tabber) When using the Feeder with other equipment, see the operator's guide fo

ASSEMBLY AND INSTALLATION 5 Connecting Power Plugging in the Feeder Make sure that the Power Switch on the Feeder is OFF. 1. Connect one end of

OPERATING THE FF-309 6 Operating the Feeder Adjusting the Feeder The Feeder is properly aligned with the Tabber when it is installed. Check alignme